Vast majority of cases we are using Windows, USB flash drives and other devices, then DOS, we can use these devices? Of course! I followed it on the system could use some improvements, the operation is not complicated.
Step 1 to produce a Windows 98 boot disk, the specific production methods would not have me say that again now!
Step 2 Download Mhairudos, Kxlrw40an two files (download addresses of ftp://ftp.dars.com.ru/support/dos_usb/mhairudos.zip, http://panasonic.co.jp/pcc/products/drive/ cdrrw/kxlrw40an/driver/kxlrw40an.exe). Then Mhairudos.zip extract, extract Di1000dd.sys file backup; Kxlrw40an.exe is a self-extracting file, after running generates F2H directory, the directory RAMFD.SYS, USBCD.SYS and Usbaspi.sys file, together with just get Di1000dd.sys files copied to the boot disk with the root directory.
Tip: Di1000dd. sys file is a DOS environment, USB device driver, RAMFD. SYS, USBCD. SYS and Usbaspi. sys files are from Panasonic in 2003, the development of a USB device under DOS application solutions, which was originally developed to be used in Panasonic's own production of the device, but as long as your computer motherboard manufacturers South Bridge is Intel, NEC, nVIDIA, VIA or SIS one, then the same applies to the program (this condition is very loose it). Also this method can be used in the DOS environment, a relatively new OHCI driver interface and the traditional two USB1.1 UHCI interface equipment, and the USB2.0 EHCI interface device.
Step 3 When the boot disk find the Config.sys file, use the "Notepad" to open, in the [CD] to any location in the following section two lines of code:
device = a: usbaspi.sys
device = a: di1000dd.sys
Step 4 in the DOS environment will need to use USB devices and PC motherboard connection, and then restart the computer into the BIOS, the first boot device to floppy disk, press the F10 key to save the exit.
Due to read the USB drive, so the computer's startup time is slightly longer than usual - startup disk will first scan the motherboard USB port, if found on the USB device port, then assigned an ID identification number (or letter) , the cycle until all the USB devices detected.
Tip: USB device drive letter occupied interface from the Windows CD-ROM drive letter began, the virtual disk (A disk drive that is mapped) and the physical CD-ROM drive letter in turn to the back row. Suppose you opened a DOS environment, flash drives, and the original hard disk partition to the end of H, now flash drives, virtual disks and CD-ROM drive letter is I, J and K.
Recommended links:
SWF to MP4The Benefits Of Satellite Internet For Rural AndFlash to MPEGDVR-MS to MPG